Page 1 of 1
Questions about "Choice Dialog"
Posted: Sat Nov 08, 2025 4:38 pm
by robotask813
When unchecking the "Use Unicode UTF-8..." box in Control Panel->Region->Management Tab->Current Language for Non-Unicode Programs, the following situation occurs.
一、Actions: "Choice Dialog", the number of Chinese characters entered (Even numbers: "变量", singular: "变", Chinese punctuation marks are also counted as 1 Chinese character)
1. The following can run normally (Even numbers Chinese characters: “变量”）
- 1.jpg (59.03 KiB) Viewed 197 times
- 2.jpg (30.6 KiB) Viewed 197 times
Re: Questions about "Choice Dialog"
Posted: Sat Nov 08, 2025 4:39 pm
by robotask813
2. The following are the situations where errors can occur (odd Chinese characters: “变”)
- 3.jpg (62.99 KiB) Viewed 196 times
- 4.jpg (30.63 KiB) Viewed 196 times
Re: Questions about "Choice Dialog"
Posted: Sat Nov 08, 2025 4:41 pm
by robotask813
3. The following are the situations where errors can occur (odd Chinese characters: “变”）
- 5.jpg (62.45 KiB) Viewed 196 times
- 6.jpg (30.47 KiB) Viewed 196 times
Re: Questions about "Choice Dialog"
Posted: Sat Nov 08, 2025 4:43 pm
by robotask813
4. The following are the situations where errors can occur (Chinese punctuation is also counted as 1 Chinese character: “、”）
The following is 1 Chinese punctuation mark + 2 Chinese characters
- 7.jpg (59.06 KiB) Viewed 196 times
- 8.jpg (29.43 KiB) Viewed 196 times
Re: Questions about "Choice Dialog"
Posted: Sat Nov 08, 2025 4:44 pm
by robotask813
The following is 1 Chinese punctuation mark + 3 Chinese characters
This case works fine.
- 9.jpg (63.95 KiB) Viewed 196 times
- 10.jpg (32 KiB) Viewed 196 times
- 11.jpg (30.44 KiB) Viewed 196 times
Re: Questions about "Choice Dialog"
Posted: Sat Nov 08, 2025 5:03 pm
by Oleg
When unchecking the "Use Unicode UTF-8..." box in Control Panel->...
This is the
same problem as
in the Input box dialog.
These dialogs has similar algorithm.